Making A Shamballa Bracelet: A Guide

1 mm thread of your favorite color( waxed cotton, nylon, or leather) Beautiful Shamballa globules of your choice having a minimum 1 mm size hole in. cube drop earring Hypo cement glueNail makeup having clear colored matin

Now follow the instructions step by step

Step 1

Make the thread easy for globules cut 40 cm length of thread also through nail makeup, add a dab to both ends of the cord, and let them dry. Now thread a blob and on one end of the cord tie a knot. Shamballa bracelet Now keeps sliding the blob until it comes 10 cm down from the knot and also tie another knot. Now just the cord on the blob mat.

Step 2

Now take a cadence length of cord and knot it into the first knot.

Step 3

Now you have to tie your square knots. Do not be puzzled it's relatively easy. Take the thread on the left and also make there a circle so that it fluently sits over the center cord.

Step 4

Pass the cord now on the right side underneath both the other cords and over through the middle.

Step 5

Now pull this knot but not too important tightly because the central cord needs to move through the knots so if you pull tightly also may be your central cord snap while wearing. Take care of it the most if you're using a leather cord.

Step 6

Now do the same effects with the right cord so that it resembles back to frontal number 4 and pass the left-handed cord beneath the other cords and over through the number 4 center now pull it tight.

You have done the first square knot!!

Step 7

Now make another knot by repeating steps 3- 6. Now to the central cord thread another blob.

Step 8

Now tie two other square knots to bring the external cords around the globules.

Step 9

Now until you get 5- 7 globules that are separated from square knots keep adding globules with two square knots between each.

Step 10

Now your external cords are nearly finished. In the two cords tie a reef knot, pull it tight and now add hypo cement to the knot. Let it dry and also crop off the external cords. Now thread on the other blob.

Step 11

Now after the last blob tie another knot at the end of the central cord and now take it off from the blob mat. Now cross over both ends of the cuff. At the end of the cord against the knots add two final globules.

Step 12

Now knot a 60 cm cord around both ends of the cuff.

Step13

Now over the main cuff cords, tie a series of square knots. ( Don't tie tightly you'll also have a problem when you open or close the cuff.

Step 14

Now if you have tied nearly 5- 6 square knots also you're nearly done. Now on the two external cords tie a reef knot and dab thy hypo cement and crop the redundant cord.